Multi-Function Display - Yamaha XT250 2009 Owner's Manual

Multi-function display

WARNING
Be sure to stop the vehicle before
making any setting changes to the
multi-function display.
settings while riding can distract the
operator and increase the risk of an
accident.
1 2
1. "SELECT" button
2. "RESET" button
3. Clock
4. Speedometer
INSTRUMENT AND CONTROL FUNCTIONS
EAU44872
1
EWA12312
Changing
1. Odometer/tripmeter (bottom)
3 4
2. Tripmeter (top)
The multi-function display is equipped
with the following:
G
a speedometer (which shows the
riding speed)
G an odometer (which shows the to-
tal distance traveled)
G
two tripmeters (which show the
distance traveled since they were
last set to zero)
G
a clock
TIP
G
Be sure to turn the key to "ON" be-
fore using the "SELECT" and
"RESET" buttons.
G When the key is turned to "ON", all
of the display segments of the
2
Odometer, clock and tripmeter
modes
Pushing the "SELECT" button switches
the display between the odometer
mode "ODO" and the tripmeter modes
"TRIP" in the following order:
ODO → TRIP (top) → TRIP (bottom) →
ODO
To reset a tripmeter, select it by push-
ing the "SELECT" button until "TRIP"
begins flashing ("TRIP" will only flash
for five seconds). While "TRIP" is flash-
ing, push the "RESET" button for at
least one second.
Clock mode
To set the clock:
1. Push the "SELECT" button and
2. When the hour digits start flashing,
4-3
multi-function display will appear
one after the other and then disap-
pear, in order to test the electrical
circuit.
"RESET" button together for at
least two seconds.
push the "RESET" button to set the
hours.
2
3
4
5
6
7
8
9