Controller - Acson ACM 30D Technical Manual

G8 Remote Controller
6
7
9
1. TRANSMISSION SOURCE
• The source where the signal will be transmitted.
2. SIGNAL TRANSMISSION INDICATION
• Blink to confirm the last setting has been send to
the unit.
3. ON/OFF BUTTON
• Press once to start the air conditioner.
• Press again to stop the unit.
4. TEMPERATURE SETTING
• To set the desired room temperature, press the
button to increase or decrease the set temperature.
• The temperature setting range is from 16°C to
30°C (Optional setting 18°C to 30°C).
• Press both buttons simultaneously to toggle the
temperature setting between °C and °F.
5. OPERATION MODE
• Press the MODE button to select the type of
operating mode.
• For cooling only unit, the available modes are :
COOL, DRY & FAN.
• For heat pump unit, the available modes are :
AUTO, COOL, DRY, FAN & HEAT.
6. FAN SPEED SELECTION
• Press the button until the desired fan speed is
achieved.
7. ON TIMER SETTING
• Press the SET button will activate the on timer
function.
• Set the desired on time by pressing the SET button
continuously. If the timer is set to 7.30am, the air
conditioner will turn on at 7.30am sharp.
• Press the CLR button to cancel the on timer
setting.
8. OFF TIMER SETTING
• Press the SET button will activate the off timer
function.
5
12
8
10
11
• Set the desired off time by pressing the SET button
• Press the CLR button to cancel the off timer
9. AUTOMATIC AIR SWING (OPTIONAL)
• Press the SWING button to activate the automatic
• To distribute the air to a specific direction, press
10. SLEEP MODE SETTING
• Press the button to activate sleep mode. This
• When it is activated in COOL mode, the set
• When it is activated in HEAT mode, the set
11. CLOCK TIME SETTING
•
14
1
2
4
3
continuosly.
setting.
air swing function.
the SWING button and wait until the louver move to
the desired direction and press the button once
again.
function is available under COOL, HEAT & AUTO
mode.
temperature will be increased 0.5°C after 0 mins,
1°C after 1 hour and 2°C after 2 hours.
temperature will be descreased 1 °C after 30 mins,
2°C after 1 hour and 3°C after 2 hours.
Press button + or - to increase or decrease the
clock time.