Controller - Acson AWM15J Manual

Application Information

Controller

G18
Operation Guide
1 Transmission Source
• The source where the signal will be transmitted.
2 Signal Transmission Indication
• Blink to confi rm that the last setting has been transmitted
to the unit.
3 Temperature Setting
• To set the desired room temperature, press the v or V
button to increase orde crease the set temperature.
• The temperature setting range is from 16°C to 30°C
(optional setting 20°C to 30°C).
4 Personalize Setting
• Press and hold for 3s, then
cycle between and
• Set the desire setting, then leave the hand set for 4s
without pressing any key and it will save the setting into the
programme.
• Press once to activate the P1 setting, press again to
cycle between P1 and P2.
• Press any key to deactivate the personalize setting.
5 Automatic Air Swing (optional)
• Press the SWING button to activate the automatic air
swing function.
• To distribute the air to a specifi c direction, press the
SWING button and wait until the louver move to the
desired direction and press the button once again.
6 Silent Function
• Press for quiet operation.
• Fan speed turn to minimum speed.
• Press again to deactivate the function.
7 Sleep Mode Setting
• Press the SLEEP button will activate the sleep mode
function. This function is available under COOL, HEAT and
AUTO mode.
• When the unit is operating under cooling mode, the set
temperature is increased by 0.5°C after 30 minutes, 1°C
after an hour, and 2°C after 2 hours.
• When the unit is operating under heating mode, the set
temperature is decreased by 1°C after 30 minutes, 2°C
after an hour, and 3°C after 2 hours.
13
P1
P2
MODE
ON OFF
TIMER TIMER
will blink. Press again to
SLEEP
TIMER
CANCEL
8 Operating Mode
• Press the MODE button to select the type of operating
mode.
• For cooling only unit, the available modes are: COOL ( ),
DRY ( ) and FAN ( ).
9 Fan Speed Selection
• Press the button continuously will toggle the fan speed
in the following order:
Low p Med p High p Auto
• Stop pressing when the desired fan speed appears on the
display screen.
10 "ON/OFF" Button
• Press one to start the air conditioner unit.
• Press again to stop the unit.
11 Timer Cancel
• Press the TIMER CANCEL button to cancel the on timer
setting.
12 OFF Timer Setting
• Press the OFF TIMER button will activate the off timer
function.
• Set the desired off time by pressing the OFF TIMER button
continuously.
13 ON Timer Setting
• Press the ON TIMER button will activate the on timer
function.
• Set the desired on time by pressing the ON TIMER
button continuously. If the timer is set to 7.30am, the air
conditioner will turn on at 7.30am sharp.
14 Turbo Function
• Press for fast cooling.
• Fan speed turn to maximum speed.
• Press again to deactivate the function.
15 Clock Time Setting
• Press and hold to set the clock time.
AWM-J-2010