Technical And Operational Parameters; Sas Bio Solid Boiler Equipment - SAS BIO SOLID 19 Operation And Maintenance Manual

1 Boiler operating and maintenance documentation (manual + warranty card)
2 Operating manual + warranty card for a temperature regulator (controller)
3 Warranty card for a blower fan
Temperature regulator (controller operating two mixing valves, Ethernet module) with a set of cables and
4
sensors for the system operation (details in the controller operation and maintenance documentation)
5 STB safety temperature limiter
6 Flue gas temperature sensor
7 Analogue thermometer
SAS MULTI FLAME pellet burner
- control unit for the burner, power strip
- blower fan
- fuel feeder with a gearmotor
8
- moving grate with drive motor, biomass furnace
- heater (electric burner)
- shape made of refractory ceramic material
- grate positioning sensor (hallotron), feeder sensor temperature
9 Moving parts guard (fuel tank casing)
10 Partition made of stainless steel, thermally insulated, protecting the furnace door
11 Partition made of stainless steel protecting the cleanout door
12 The set of refractory ceramic panels: rear front, sides, horizontal partitions***
13 The set of refractory ceramic panels - boiler side wall opposite the biomass furnace
14 Flue gas turbulator
15 Fuel tank
16 Feeder flap opening sensor
17 Ash drawer
18 Pressure relief valve (2.5 bar)
19 A set of tools for boiler operation (poker, cleaning rod, scraper, and ash shovel)
20 Adjustment feet for boiler levelling (excluding boilers above 25 kW)
21 Connector (G ½) of the overheating protection
the number of horizontal ceramic partitions over the furnace is dependent on the power of the boiler
***
1 Room regulator
2 Module controlling an additional mixing valve
3 GSM module
*)
Thermostat valve with a capillary tube (G ½ ") protecting against overheating:
4 - open vented system with a plate exchanger (e.g. Regulus, type BVTS)
- sealed system (e.g. SYR 5067)
applies to boilers with a TECH controller
*)

5. TECHNICAL AND OPERATIONAL PARAMETERS

Basic power parameters together with technical and operational parameters
for SAS BIO SOLID boilers are listed in Tab. 2, and Fig. 6.
18
Table 1. SAS BIO SOLID boiler equipment
BOILER STANDARD EQUIPMENT
OPTIONAL BOILER EQUIPMENT
*)
1
pieces
1
pieces
1
pieces
1
pieces
1
pieces
1
pieces
1
pieces
1
set
1
set
1
pieces
1
pieces
1
pieces
1
set
1
pieces
1
pieces
1
pieces
1
pieces
1
pieces
1
set
4
pieces
1
pieces
1
pieces
1
pieces
1
pieces
1
pieces