M10 Washers (91), And Two M10 Nylon Locknuts - ICON WEIDER PRO 9400 User Manual

57. Press two 20mm x 40mm Inner Caps (116) and a
25mm x 40mm Inner Cap (117) into the Seat
Bracket (11).
Attach the Seat (16) to the Seat Bracket (11) with
two M6 x 16mm Screws (114), an M6 x 35mm
Screw (99), and an M6 Washer (97).
Loosen the indicated Adjustment Handle (65). Next,
pull the Handle and insert the Seat Bracket (11) into
the Seat Frame (8). Engage the Handle into one of
the holes in the Seat Bracket, and retighten the
Handle.
58. Press two 20mm x 40mm Inner Caps (116) and a
25mm x 40mm Inner Cap (117) into the Backrest
Bracket (13).
Attach the Butterfly Backrest (15) to the Backrest
Bracket (13) with four M6 x 16mm Screws (114).
Loosen the indicated Adjustment Handle (65). Next,
pull the Handle and insert the Backrest Bracket (13)
into the Butterfly Upright (3). Engage the Handle
into one of the holes in the Backrest Bracket and
retighten the Handle.
59. Wet one end of the Squat Arm (32) with soapy
water. Slide a Short Pad (20) onto the Squat Arm
as shown.
Attach a Squat Handle (33) to the Squat Arm (32)
with two M8 x 20mm Button Head Screws (51).
Slide an Outer Cap w/Hole (111) onto the Squat
Handle and press it onto the end of the Squat Arm.
Wet the Squat Handle with soapy water. Slide a
200mm Handgrip (84) onto the Squat Handle.
Repeat this step with the other end of the Squat
Arm (32).
60. Attach the Squat Arm (32) to the Squat Bracket (37)
with two M10 x 65mm Carriage Bolts (110) and two
M10 Nylon Locknuts (87). Do not tighten the
Locknuts yet.
Finish attaching the Squat Arm (32) to the Squat
Bracket (37) with two M10 x 70mm Carriage Bolts
(106), two M10 Washers (91), and two M10 Nylon
Locknuts (87).
Tighten all of the M10 Nylon Locknuts (87) used
in this step.
57
16
11
116
114
58
15
59
32
51
87
60
91
87
32
20
116
97
99
117
8
65
3
116
114
65
117
114
13
116
20
51
20
33
111
84
91
110
106
37