Audio Set Menu - Sony 50P Operating Instructions Manual

Operating the Menus

AUDIO SET menu

Submenu
Icon/Menu
(page)
AUDIO SET
AUDIO
A
MODE
(page 74 (GB))
AUDIO DUB
(page 74 (GB))
JOG AUDIO
REF LEVEL
(page 20 (GB))
AGC CH1,2
(page 21 (GB))
AGC CH3, 4
(page 21 (GB))
88
(GB) Chapter 6 Adjusting and Setting Through Menus
Setting
Selects the audio mode.
FS32K : Switches the audio mode to the four channel mode (12-bit mode).
FS48K: Switches the audio mode to the two channel stereo mode (16-bit mode). (This
setting records the sound in all audio ranges, providing a high-quality sound recording.)
Notes
• This item is disabled when inputting signals from the DV IN/OUT connector.
• You cannot display the selection screen while in the recording mode.
• Noise may occur at the moment you switch the audio mode.
Selects the input channel for audio dubbing.
CH1,2: Selects channels 1 and 2.
CH3,4 : Selects channels 3 and 4.
OFF: Disables audio dubbing.
Note
You cannot display the selection screen while dubbing the sound.
Turns sound output on/off when the tape is played at a speed other than normal.
OFF : Does not output the sound when playing a tape at a speed other than normal.
ON: Outputs the sound when playing a tape at a speed other than normal.
Note
Even if you have set this item to ON, the sound may not be output or interrupted depending
on the tape format or tape conditions.
Switches the center levels of the audio level meters displayed on the FINE screen.
–12dB: Sets the level to –12 dB
–18dB: Sets the level to –18 dB
–20dB: Sets the level to –20 dB
Notes
• The default is –20 dB for DSR-50; –18 dB for DSR-50P.
• The standard output level of the AUDIO OUTPUT jacks is –10 dBu. This is equivalent to
–20 dB for DSR-50, or –18 dB for DSR-50P from full bit (maximum audio level). This level
is fixed and does not change even if you change the REF LEVEL setting.
• Changing this level does not change the audio gain of this unit. Turn the audio recording
level control knobs to adjust the recording level accordingly.
Links/separates the AGC (Auto Gain Control) in channels 1 and 2.
SEPARATE : AGC is not linked. (Channels 1 and 2 sound gains are separated.)
LINKED: AGC is linked. (Channels 1 and 2 sound gains are linked as a pair.)
Notes
• This setting is disabled when inputting signals from the DV IN/OUT connector.
• The LINKED setting is enabled after you set the AUDIO SELECT switches on the front
panel to AUTO for both channels 1 and 2.
Links/separates the AGC (Auto Gain Control) in channels 3 and 4.
SEPARATE : AGC is not linked. (Channels 3 and 4 sound gains are separated.)
LINKED: AGC is linked. (Channels 3 and 4 sound gains are linked as a pair.)
Notes
• This setting is disabled when inputting signals from the DV IN/OUT connector.
• The LINKED setting is enabled after you set the AUDIO SELECT switches on the front
panel to AUTO for both channels 3 and 4.