Set-Up Menu Descriptions - Sony SVO-5800 Operating Instructions Manual

Set-up Menu Descriptions
e Factory default settings are marked with a frame (__].
Menu items Description
OPERATIONAL FUNCTION (1000) Settings relative to the operation of the unit
AUTO EE SELECT (1001) (SVO-5800/5800P only)
Determines the mode in which the unit outputs the video/audio input signals from
other equipment when the unit received a stop command through the 9-pin REMOTE
connector.
Outputs the playback signal of the tape.
Outputs in EE mode.
Selects which of the tape transport control buttons operate when the REMOTE/LOCAL
switch is set to REMOTE.
Only the STOP and EJECT buttons are enabled.
All of the tape transport control buttons are disabled.
Sets the preroll time in seconds, from 0 to 15 when the REMOTE/LOCAL switch is set
to REMOTE. ( If it is set from the editing control unit connected to the 9-pin REMOTE
connector, this setting is ignored and the editing control unit setting takes precedence.)
00 SEC (00) -|5 SEC (05)
15 SEC (15)
PLAY START (1004)
LOCAL ENABLE (1002)
ALL DISABLE (01)
PREROLL TIME (1003)
Sets the timing for switching to playback mode from stop mode in frames, from 4 to 16.
It minimizes the phase adjustments and reduces the preroll time when editing.
04 FRAME DELAY (04) -|0 (0:
— 16 FRAME DELAY (16)
LTC EDIT COM. (1005) (SVO-5800/5800P only)
Sets the command for insert editing of LTC from the 9-pin REMOTE connector.
A3 (TC) (00) LTC recording for only A3 command.
A28&A3 (TC) (01) LTC recording for A2 and A3 commands.
CUE-UP SPEED (1006) Setting of cue-up operation
& REW (00)
When the cue-up point is more than a minute away, the unit fast forwards or rewinds
the tape.
SHUTTLE MAX SPEED (01)
Cue-up operation always occurs in the shuttle mode.
or not.
OFF (00) Does not output the text information.
Outputs the text information.
Sets the position of the characters to be displayed on the monitor screen. Set while
watching the monitor screen.
01,01 — [11,06 |- 11,11 (SVO-5800/SVP-5600)
01,01 - /13,06 |- 13,11 (SVO-5800P/SVP-5600P)
The first two digits are for vertical direction, and the latter two digits for horizontal
direction. As the number gets bigger, the position moves toward the bottom and
the right. The factory default setting is in the bottom center of the screen.
CHARA. POSITION (2002)
Changing the Settings of the Unit — Set-up Mes
a ar dale || |||(|||
45(E)