User 1 And User; Recall - Ten-Tec Orion 565 Manual

(21) USER 1 AND USER 2

ORION is equipped with a total of five user
profiles. User profiles are like a "super
memory" – everything on the radio, all
settings, all menu selections, everything will
be saved to a user profile memory. Unlike
traditional memories that save frequency,
mode, bandwidth and maybe one or two
other parameters.
The USER 1 and USER 2 buttons allow
saving and recalling of user profile #1 and
user profile #2. User profiles #3, #4 and
default (#5) are accessible by pressing the
RECALL button (22).
To save a user profile in either USER 1 or
USER 2: Press and hold the desired button
for two seconds. Two messages will appear
on the screen: STORING PARAMETER
SET and then STORE COMPLETE.
To recall user profile #1 or #2, momentarily
press and release the USER 1 or USER 2
buttons. A series of messages will appear
on the screen while ORION recalls stored
information: RECALLING PARAMETER
SET, RESTORING USER MENU SET,
RESTORING RADIO STATE, and RECALL
COMPLETE.

(22) RECALL

The RECALL button has two different
functions. One is to allow recall of saved
memories that have been entered using the
200 available "traditional" memories. The
other function is to allow the operator to
quickly recall the factory defaults for ORION
or to select one of the four programmable
user profiles.
To use RECALL to bring up either the
factory default settings or a stored user
profile, press and hold the RECALL button
for two seconds. A submenu will appear,
titled FACTORY DEFAULTS and two
options EXIT (using button 22) and RECALL
(using button 24) will appear at the bottom of
the screen. The operator can scroll among
the factory defaults and the four user profiles
by turning the MULTI knob located to the
upper right of the screen. When turned, the
submenu display will change to read
PARAMETER BACKUP #1, #2.....etc. The
565 manual
Part #74279
Printed in USA
options of EXIT, STORE, and RECALL are
given.
Factory defaults will return the radio to the
state as after doing a master reset.
Note that PARAMETER BACKUP #1 and
PARAMETER BACKUP #2 are duplicates of
the user profiles that can be saved and
recalled by using the USER 1 and USER 2
buttons. #3 and #4 and factory defaults are
only accessible via this RECALL submenu.
RECALL is also used for recalling the
traditional memories saved using the VFO
A>M and VFO B>M buttons. To access the
recall of memories, momentarily press and
release the RECALL button. A submenu
titled MEMORY RECALL will appear.
Stored memories can be examined using
the MULTI knob. Turn the MULTI knob to
see all stored memories with frequency and
mode information.
Four options are shown under the memory
locations: EXIT, M>VFO A, M>VFO B, and
DELETE. Each of these functions uses
buttons 22 through 25, directly under the
options shown on the screen.
To recall a stored memory to VFO A, press
M>VFO A (button 23). To recall a stored
memory to VFO B, press M>VFO B (button
24). To delete a stored memory, press
DELETE (button 25). To exit the memory
recall submenu, press EXIT (button 22).
(23) NB
The ORION is equipped with a DSP noise
blanker that is independently adjustable for
each receiver.
To adjust the DSP noise blanker, press NB
(button 23). A value of 1 through 9 will
appear on the screen just above the NB
button. Use the MULTI knob to adjust the
noise blanker value from 1 to 9. A higher
value indicates more aggressive noise
blanker action – please note that high noise
blanker settings on loud SSB signals can
lead to intermodulation distortion of received
signals.
September 2003
14