User 1 And User; Recall - Ten-Tec ORION II Manual

23) and begin speaking into the microphone.
There are 4.54 seconds of available
recording time for each of the SEND 1 and
SEND 2 voice memories. When RECORD
is pressed, the legend on the screen above
the button changes to read STOP.
When you are finished recording the
message, press the button again to STOP.
When finished, you can check the recording
off the air by pressing PLAY (button 24).
To delete the recording, press DELETE
(button 25).
To retain the memory after the transceiver is
powered off, press SAVE (button 26). A
message titled SAVING RECORDING will
appear on the ORION II screen for several
seconds during the save process.
To exit the voice recorder control menu,
press EXIT (button 22). Don't forget before
pressing EXIT to release the PTT button on
your microphone that you depressed earlier
to record the message, or upon exiting your
mic will be live.
To play your message while on the air,
momentarily push the appropriate SEND
button and your recording will be
transmitted.
To record a message in a voice mode in
SEND 3: Follow the same instructions as
for SEND 1 or SEND 2. SEND 3's message
can be up to 28.1 seconds in length but
cannot be retained in memory by using the
SAVE button after recording. This memory
will erase after the transceiver is powered
off.
To record a message in CW mode in SEND
1, SEND 2, or SEND 3: Press and hold the
appropriate button . A submenu titled CW
MEMORY KEYER CONTROL will appear at
the bottom of the screen.
Please note: CW memories can only be
recorded using the internal keyer.
There are four options: EXIT, RECORD,
PLAY, and DELETE. The four buttons
below these options (numbers 22 through
25) are used for these functions. Unlike
voice memories, all 3 CW memories are
automatically saved to memory when
566 manual
Part #74410
Printed in USA
recorded and will retain after powering off
the transceiver.
To record a message in CW mode, press
RECORD (button 23) and begin sending
CW. The words EXIT, RECORD, PLAY,
and DELETE will momentarily disappear
and the word STOP will appear above
button 23. When you have completed your
recording press button 23 to end (STOP).
To check your CW memory off the air
without transmitting, press PLAY (button
24). To delete the CW memory, press
DELETE (button 25). To exit the CW
memory keyer control menu, press EXIT
(button 22).
When playing your CW message on the air
using SEND 1, SEND 2 or SEND 3, the CW
keyer must be turned on. If off, the SEND
buttons will not respond.

(21) USER 1 AND USER 2

ORION II is equipped with a total of five user
profiles. User profiles are like a "super
memory" – everything on the radio, all
settings, all menu selections, everything will
be saved to a user profile memory. Unlike
traditional memories that save frequency,
mode, bandwidth and maybe one or two
other parameters.
The USER 1 and USER 2 buttons allow
saving and recalling of user profile #1 and
user profile #2. User profiles #3, #4 and
default (#5) are accessible by pressing the
RECALL button (22).
To save a user profile in either USER 1 or
USER 2: Press and hold the desired button
for two seconds. Two messages will appear
on the screen: STORING PARAMETER
SET and then STORE COMPLETE.
To recall user profile #1 or #2, momentarily
press and release the USER 1 or USER 2
buttons. A series of messages will appear
on the screen while ORION II recalls stored
information: RECALLING PARAMETER
SET, RESTORING USER MENU SET,
RESTORING RADIO STATE, and RECALL
COMPLETE.
Version 4 – October 2006 12