Pwr; Mon - Ten-Tec Orion 565 Manual

(17) PWR

This button is used for setting RF power
output on ORION. Press the PWR button
then turn the MULTI knob to adjust value
from 1 to 100. The value set from 1 to 100
will roughly correspond to power output in
watts but this will vary a few watts
depending on band and load impedance.
The PWR button also interacts with the
TUNE button (40) for key down power
output for tuning an antenna tuner or linear
amplifier. See the description of TUNE
(button 40) later in this section.
If the low level drive transverter output has
been activated in the menu system, a low
level output RF output level of approximately
+15 dBm will be sent through the XVRT RF
jack. This output power value is adjustable
from +5 to +15 dBm by using the PWR and
565 manual
Part #74279
Printed in USA
MULTI control when the transverter output is
activated in the menus.

(18) MON

ORION is equipped with a transmit audio
monitor to allow the operator to hear actual
transmitted audio. TX EQ, speech
processing, TX bandwidth, LF rolloff all have
an effect on the sound of the transmitted
SSB signal, and to properly adjust these
controls for no distortion and desired sound,
use the monitor.
Press the MON button. The volume of
monitor level is expressed as a value from 1
to 100% of available. Monitor is available
through either headphones or via the
speaker.
The MON function is also usable in FSK
mode for monitoring of transmitted tones.
September 2003
12