Alc - Ten-Tec Orion 565 Manual

so, press the PWR button immediately after
pushing the TUNE button. Power output will
move from the low power setting to
whatever level the PWR control has been
set at with the MULTI knob. Repeat
operation will require pushing TUNE then
PWR again for the higher output value.

ALC

The ALC light just to the left of the S-meter
is used to indicate when automatic level
control action for the set output of the radio
has been reached. It will flash on and off
with all CW characters transmitted. On
SSB, the ALC light should light on voice
peaks to indicate proper adjustment of
microphone gain.
At very low power outputs, the ALC light will
be lit continuously when transmitting in SSB
modes. This is normal.
565 manual
Part #74279
Printed in USA
September 2003
20