Performing Initial Setup Operations - Sony RMN-U1 Operating Instructions Manual

Performing initial setup operations

When the unit is turned on for the first time after
you purchase it, some basic set-up operations are
required, for example, initial settings and network
settings.
Entering characters will be needed during the setup
operations. For details on entering characters, see
"Entering text" (page 19).
1
Turn the DLNA (Digital Living
Network Alliance)-compliant
devices in your home on.
2
Slide the ?/1 switch in the
direction of the arrow if the unit is
turned off.
The language selection screen appears.
3
Tap the language you want to
select, then tap
You can select from the following languages.
Display
English
Français
Deutsch
Italiano
Español
The screen is displayed in the selected
language.
"OK."
Language
English
French
German
Italian
Spanish
4
Connect the unit to your home
network.
Set up the network after checking your
network environment. Refer to the following
explanation.
•
If you use the access point scan method,
perform step 4 in "Searching for an access
point and setting up a wireless network
(access point scan method)" (page 24).
•
If you use the WPS push button
configuration method, perform step 4 in
"Setting up a wireless network using the
WPS push button configuration method"
(page 26).
•
If you use the PIN method, perform step 4
in "Setting up a wireless network using the
PIN code method" (page 27).
"Connection is complete." appears when you
have completed the network connection.
5
Tap " Close ."
A confirmation screen appears.
6
Tap " ."
Close
The unit starts registering the
DLNA-compliant devices that can be
recognized over the network, automatically.
This may take a while.
Tips
•
You can register up to 20 servers and up to
30 renderers (network controlled players)
on this unit.
•
Tap " Refresh" to refresh the HOME
screen if the desired device is not
registered automatically.
21 GB