Updating The Firmware; Updating The System Application - Sony RMN-U1 Operating Instructions Manual

Updating the Firmware

Updating the system
application
By downloading the latest version of the system
application, you can take advantage of the newest
functions. The unit accesses the Sony server to
update the system.
When a new update is available, you will be
notified by a message that appears on the screen
while the unit is on and connected to the Internet.
Note
Make sure you do not attempt any of the following
operations while the update is in progress.
–
Turn the unit off
–
Disconnect the network cable
–
Remove the unit from the remote control charger
1
Place the unit on the remote
control charger.
2
Press HOME on the unit.
The HOME screen appears.
3
Tap " Settings."
4
Tap "System Update."
One of the following messages appears on the
screen.
"Found the latest software. Update?" :
Proceed to step 5.
"The software is up to date. It does not need
to be updated." : A firmware update is not
needed. Tap "Close" to exit this screen.
5
Tap " ."
OK
6
Follow the on screen instructions.
The unit starts to update the system
application. It may take a while (about 20
minutes at the longest) for the unit to finish
the update. The required time will depend on
the amount of data in the updates, the line
type of the network, the network
communication environment, etc.
When the system update finishes, the unit
restarts automatically.
Notes
•
Do not remove the unit from the remote control
charger until the update has been completed.
•
Reboot the unit once or twice after the update.
To cancel the procedure
Select "Cancel" in step 5.
71 GB