The Motomed Is Not Working At All Or Operating Panel Is Not Reacting; The Motomed Stops And Generates An Error Message; Simple Error; Electronic Error - RECK MOTOmed viva2 Instruction Manual

The MOTOmed is not working at all or the operating
panel is not reacting
Please check the connection of the operating panel. The mains plug
needs to be properly connected to the socket. Please also verify that
the power supply connection by the external power supply to the
MOTOmed device is correct. Please also check the functionality of your
wall socket (by plugging in another electronic device).

The MOTOmed stops and generates an error message

Simple error

fig. 68
example of display of a simple
error
check the listing of the displayed error code if you can find the cause
and the solution of the error in the following overview and follow
the instructions. If the error reoccurs, please contact your MOTOmed
representative or the technical support department at the RECK
Company.

Electronic error

Any electronic error requires disconnection of the power supply
(unplug the MOTOmed). The individual device settings will not be lost.
In most cases a simple error, can
be cleared by pushing the »start/
8
stop«-button and restarting
the device. The individual device
settings will not be lost. If the
restart did not solve the problem,
please disconnect the MOTOmed
from the power supply (disconnect
the mains) for a short while and
start the MOTOmed again. Please
TROUBLESHOOTING
6
65