RECK MOTOmed letto2 Short User Manual

MOTOmed
1

Attaching to the bed unit

1 a Loosen the fixation screw of the height adjustment
the drive unit to slide up
Once the MOTOmed letto2 is positioned correctly, lock the ground
fixation (Four-Brake-Stop)
1 b If your MOTOmed letto2 is equipped with a "expandable chassis"
, you can adjust it with the control lever
(accessory, item no. 160)
according to your needs.
2

Adjustment of the training height

2 a Use the handlebar to adjust the desired training height, then retighten
the fixation screw of the height adjustment
that the foot shells do not strike
2 b If your MOTOmed letto2 is equipped with a "hydraulic height
adjustment"
(accessory, item no. 173)
comfortably by pushing (raised drive unit) or pulling up (lowered drive
unit) the foot pedal.
3

Foot shells and leg guides

3 a After initialization is completed, insert the feet into the foot shells
and fasten them with the fixation straps
3 b If your MOTOmed letto2 is equipped with a "TrainCare Comfort"
, you can assure a safe insertion of the calves and
(accessory, item no. 168)
prevent overstretching of the knees, by placing the legs into the calf
shells one after the other and fastening them with the
Please make sure that the expander cords run through the plastic
coils as indicated
(fig. "correct/wrong")
incorrectly they can cause a safety issue and can wear out quickly.
4

Knee bending adjustment

4 a Before inserting the legs loosen the wing screw
adjustment and move the crank toward the user or away from him.
Retighten the wing screw securely.
4 b If your letto2 is equipped with a "knee bending adjustment"
. You can use the thumb wheel to adapt the
item no. 162)
knee bending adjustment exactly at all times, even during the training.
Make sure that the user's knee joints are slightly bend at the biggest
distance between the user and the safety foot shells.
5

Pivoted operating panel incl. operator remote stop:

5 a Rotate the operating panel
user with access to the operator remote stop
the cable does not come in the training area of the foot shells.
5 b If the MOTOmed letto2 that you are using is equipped with a
"pivot arm for operating panel"
position the operating panel in a direction that is more accessible
for the user. The user can read off the training data easier which
allows for a better control of the training session.
MOTOmed move differently
movement therapy: passive, motor-assisted, active resisted
letto2
Short User Guide: Preparation
®
with the help of the pneumatic system.
by pushing the red part of the foot pedal.
. Please make sure
the bed while in the lowest position.
, you can adjust the training height
.
. If the expander cords are positioned
of the longitudinal
towards the user and provide the
. Pay attention that
(accessory, item no. 166)
and allow
straps.
correct
(accessory,
strength of the
, you can
wrong