Table of Contents
Advertisement
Installation: Handling and set-up
4
!
5
6
Plug the room unit into a power socket.
Electrical supply
•
If an extension cable is used the following specifications must be complied to.
Extension cable
(length)
max. 10 m
10 m and more
Improper use of cables or using insufficient cable type can cause short circuit and fire
Warning
CAUTION
hazard
•
Caution
•
Connect the pipes to the
a.
heat exhanger and
b. room unit
Pull the coupling of the female pipe
adapter back in order to connect the
pipes.
Be prepared with an old cloth or alike
to wipe the water/glycol mixture up,
since it will spill a bit, when the pipes
are connected.
a.
Connect the heat exchanger
power cord to the ACT-7 room
unit using the socket provided.
b. Push the gray ring towards the
machine.
c.
Turn clockwise to lock the con-
nection.
Repeat a + b + c when connecting the
power cord to the heat exchanger.
Connect the electrical power cord to
the room unit.
NB: See specifications of the electrical
supply in the section "Electrical sup-
ply" on page 9.
As standard the ACT-7 requires a fused electrical supply (UK 13A, Europe 16A) rated at
230 Volts, ~1N, 50Hz. The ACT-7 is equipped with a UK plug (CEE 7/7) as standard.
Extension cable
(min . width)
2,5mm
2
4,0mm
2
Use extension cable with the right specification (be aware that most domestic propri-
etary extension cables are 1,5mm
If the cable is on a 'cable drum' then ensure that it is completely unwound in accordance
with the manufacturer's instructions
a
a
- this is not sufficient)
2
b
b
c
9
Advertisement
Table of Contents
