Example: To store the On/Off
signal of an air-conditioner to
the SYSTEM CONTROL 2 button
1
Place the Commander head to
head with the remote control of
the air-conditioner.
Remote control of
your air-conditioner
about 2 – 4 inches
(5 – 10 cm) away
2
While pressing COMMANDER
OFF, press CHANNEL + and
VOLUME +.
"LEARN" appears and the display
that stands for the learnable SYSTEM
CONTROL buttons flashes in the
display panel.
If a signal has been learned on that
button, the display stays lit. If you
want to program on that button, clear
the signal first (page 40).
3
4
RM-AV2100
5
Press the SYSTEM CONTROL
button you want to teach.
"LEARN" flashes and the display for
the pressed SYSTEM CONTROL
button stays lit.
Press and hold down the button
of the remote control until you
hear a beep.
(If you release the button before you
hear a beep, the signal may not be
learned correctly.)
"LEARN" display stops flashing and
stays lit.
If "NG" flashes on the display
Learning did not succeed. Try Steps 3 and
4 again.
Press COMMANDER OFF.
Continued
39