Sony RM-AV2100B Operating Instructions (primary manual) Operating Instructions Manual page 19

When you teach the signals of an
air-conditioner
See the notes on page 39.
To display only the frequently
used keys
You can hide keys you do not use. This
makes operations even easier to
understand, when the components have
many keys.
After Step 2 on page 16, while pressing
the RESET key, press the key you want to
hide (flashing). The pressed key changes
to slower flashing and will no longer be
displayed during remote control
operations.
To display it again, perform the same
procedure again.
Note
You can not hide a key which has "learned"
any signal.
To change the function display of
a key
When you program a signal for a key,
you can select the most suitable function
display among all the displays the key
has, and set it to the key.
1
After Step 2 (page 16), while
pressing the Component Select
button (VCR1), press the key you
want to teach repeatedly.
Each time the key is pressed, the
display is changed in order.
2
When the desired display
appears, release the Component
Select button.
3
Then follow Steps 4 to 6 (page
17).
Notes
• You can change the display of a key only
when you program it using the learning
function. If you want to change the display of
the key that has learned a signal, clear the
signal first (page 20). Then teach the key
again using the above procedure to change its
display.
• If you don't change the display of a key, the
default display is used.
• You cannot change the display of the keys
that are not framed with
keys 0 to 9, +10 and ENTER).
(the numeric
Continued
19