Set Supervisor / User Password - Acorp 4S651M Manual

Chapter 2

2.13 Set Supervisor / User Password

Phoenix - AwardBIOS CMOS Setup Utility
Standard CMOS Features
Advanced BIOS Features
Advanced Chipset Features
Integrated Peripherals
Power Management Setup
Enter Password:
PNP/PCI Configurations
PC Health Status
Esc : Quit F9: Menu in BIOS
F10 : Save & Exit Setup
When you select this function, the following message will appear
at the center of the screen to assist you in creating a password.
Type a password, up to eight characters, and press <Enter>.The
password you type now will clear any previously entered
password from CMOS memory. You will be asked to confirm the
password. Type the password again and press <Enter>. You
may also press <ESC> to abort the selection and not enter a
password. To disable the password, just press <Enter> when
you are prompted to enter a password. A message will confirm
that you wish to disable the password. Once the password is
disabled, the system will boot without asking user to enter a
password.
Password for System or BIOS Setup
If you select "System" at the Security Option of BIOS Features
Setup Menu, you will be prompted for the password every time
when the system is rebooted, or any time when you try to enter
Setup. If you select "Setup" at the Security Option of BIOS
Features Setup Menu, you will be prompted only when you try
to enter Setup.
Time , Date , Hard Disk Type ...
Enter Password (for Supervisor/User)
2-58
4S651M/4S651MN BIOS Setup
Frequency/Voltage Control
Load Fail-safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit without Saving
←→↑↓: Select Item