Tabletop Configuration - Arturia AudioFuse 8 Pre User Manual

4.1.2. Tabletop configuration

AudioFuse 8Pre with rack ears facing downward and rear feet installed
Mount the rack ears as shown in the illustration above, with the Arturia logo on the left side
of the AudioFuse 8Pre. Before you do, though, read the following instructions.
1. Two semi-circular rubber pads are included. Stick these onto the rack ears at the
spot that will become the "feet". This will help prevent scratches on the surface
where you place the AudioFuse 8Pre.
2. Attach the rubber pads so that the straight edge aligns with the 90º bend in the
rack ear, and then press the circular portion of the pad firmly onto the rack ear
in the direction of the two large screw holes.
3. Be sure to mount the rack ears so they are pointing under the AudioFuse 8Pre
(toward its center), not pointing away.
4. Also included are two "feet" made of plastic and rubber that should be mounted
to the rear of the bottom panel. They will enhance the physical stability of the
AudioFuse 8Pre when it is placed on a flat surface.
5. These feet have small plastic guide pins that help them seat properly on the
bottom panel. Once you line those up it will be easy to fasten them into place
with the provided screws.
6. When the feet are properly installed the AudioFuse 8Pre will be supported in four
places: the left and right rack ears (under the front) and the left and right feet
(under the back).
7. The AudioFuse 8Pre will now be completely elevated above the surface where it
will be placed.

♪: It's okay to place a laptop, a monitor, or another rack unit on top of the AudioFuse 8Pre if needed.
21 Arturia - User Manual AudioFuse 8Pre - Setting up the AudioFuse 8Pre