Output Connectors; Input Channels 1 And 2 - Arturia AudioFuse 8 Pre User Manual

2.2.2. Output connectors

# Connector name
1 Stereo speaker outputs
2 Output channels 1-8
2.2.2.1. Stereo speaker outputs
Adjust these outputs directly with the large control knob on the front panel. They are
designed to send audio to your studio monitors, and can be switched between the Main 1-2
output and the Cue mix as defined by the front panel controls or the AFCC.
2.2.2.2. Output channels 1-8
These outputs can be freely assigned in USB mode using the AFCC. You can set them up as
additional stereo pairs, individual outputs for particular instruments such as a monosynth, or
use them as additional speakers with a DAW that has surround-sound mixdown capabilities.

2.2.3. Input channels 1 and 2

We're going to jump over channels 3-8, but we'll describe them in
Input channels 1 and 2 are shared with the front panel connectors. The connection will
switch automatically to the front panel when something is plugged in there. But as soon as
you disconnect the cable on the front panel, the connection to the rear panel will be restored.
15
the next section
Arturia - User Manual AudioFuse 8Pre - Overview
[p.16].