4.1 Logon to the Console
Once the terminal is connected to the device, power on the Managed Switch, and
the terminal will display "running testing procedures".
Then, the following message asks for the login user name and password. The
factory default user name and password are as follows as the login screen in
Figure 4-3 appears.
Username: admin
Password: admin
Figure 4-3 Managed Switch Console Login Screen
The user can now enter commands to manage the Switch. For a detailed descrip-
tion of the commands, please refer to the following chapters.
1. For security reason, please change and memorize the new
password after this first setup.
2. Only accept command in lowercase letter under console inter-
Note
face.
4.2 Configuring IP Address
The IP address configuration commands for VLAN1 interface are listed below.
Before using in-band management, the Managed Switch must be configured with
an IP address by out-of-band management (i.e. console mode). The configuration
commands are as follows:
SGS-6341-Series# config
SGS-6341-Series(config)# interface vlan 1
SGS-6341-Series(config-if-Vlan1)# ip address 192.168.1.254 255.255.255.0
7