Wago Drawing - BENETEAU Oceanis 351 Manual

13.12.3. Wago Drawing

The panel is wired to the boat thru a "Wago" wiring block strip. The boat's wiring harness and the panel
are connected together at the wiring block strip using a series of plugs from each that snap onto opposite
sides of the wiring block strip. Each of the boats positive 12V circuits connect to it's circuit breaker in
the panel this way, ie:Wire #7 "Deck Light' connects across the wiring block to circuit breaker #7 on the
panel. The negative side of the circuits lead to a common ground.
P A N E L P L U G S
Each strip on the wago wiring block is an individual block mounted side by side on a
frame to form the wiring block strip. These individual blocks can be connected to the
blocks on either side of it to create a larger circuit as in the saloon lights. Wires are
inserted into the block by:
1.
2.
3.
Remove wires by inserting the screwdriver and pulling out the wire.
Oceanis 351
Rev. 00
11/6/2006
N A V L I G H T S 1 1 0
WA T ER P U M P 1 3
BI L GE P U M P 1 4
3 0
3 0
3 0
3 0
3 0
3 0
Inserting a small screwdriver into the inside hole and pressing down.
Insert the wire.
Remove the screwdriver
B O A T H A R N E S S
67
9:02 AM
P L U G S