Operation; Fresh Water Drawings - BENETEAU Oceanis 351 Manual

13.5.2.
1. Fill the water tanks.
2. Select the tank for use at the valves on the manifold.
3. Turn on the fresh water pump at the panel.
4. Open all taps and bleed off any trapped air in the lines until the water runs clear
with no sputtering.
5. Close all taps and the pump will turn off when it reaches operating pressure. If the
pump continues to cycle check all fittings for leaks.
•
Never top up with water and diesel at the same time if the filling points are close
to each other, to avoid the risk of contaminating one liquid with the other.
• Similarly, avoid risk of contamination by never handling a product that might
cause pollution close to the deck fill while taking on water.
•
If unused for a long time, the tanks and pipes need to be flushed with a solution of
acetic acid (solution of vinegar and water).
•
The sink and wash-basins are drained through their own through-hull valves; these
should be kept closed when the fresh water system is not in use.

13.5.3. Fresh Water Drawings

1. Pump House (Under PortMidship Settee)
2. Fwd Water Tank
3. Fwd Water Tank Supply Line
4. Aft Water Tank
5. Aft Water Tank Supply Line
6. Hot Water Heater
Oceanis 351
Rev. 00
11/6/2006

Operation.

7. Galley Sink
8. Galley Sink Supply Lines
9. Head Sink & Shower
10. Head Supply Lines
11. Transom Shower Supply Line
12. Transom Shower Valve
13. Transom Shower
52
8:54 AM