Advertisement
CENTRE PORTAL FRAME DETAILS
1 required.
80mm
1x Knee plate
NOTE: If you have a slab with an edge rebate in your concrete slab, you will have to cut an amount
off the bottom of the frame legs equal to the depth of the rebate.
Absco Industries
Assembly Instruction Manual
ABSCO WORKSHOP SHED
MODEL: 45232WK
4.48mW x 2.26mD x 2.00mH
TIP: An easy way to make sure that the angle
at the top of the portal frame is correct is to
use the gable wall panel as a template to lay
the sections out. As the portal frame fi ts inside
the walls, the width of the frame will be 40mm
less than the gable wall panel.
2210mm
2950mm
2x Apex plates
Model: 45232WK
PART C1106
PART C1482
PART C1704
NOTE:
CENTRE PORTAL ASSEMBLY for
photos of the process.
1x Knee plate
27/09/2018
Refer
to
the
section
1.30
25
Advertisement
