Advertisement
Guide on Joining a Spliced Ridge Beam
Follow these three steps to assemble a ridge beam.
Step 1.
Place two ridge beams as
shown and push them together.
Slide the cap of one under the
other.
Step 3.
Turn over the ridge beam.
Measure 250mm from the
middle along the centre of one
ridge beam, mark spacings of
50mm. Fasten with a Tek screw
at each marking.
Absco Industries
Assembly Instruction Manual
ABSCO WORKSHOP SHED
MODEL: 45232WK
4.48mW x 2.26mD x 2.00mH
NOTE.
There is a 50mm overlap of the
ridge caps when the beams are
in position.
Repeat to the other side of the
ridge beam assembly.
TIP: Predrilling each hole with
the 3mm drill bit makes it easier
to fasten.
Tek screw driver bit
Self drilling Tek screw
Ridge Beam
Push
ZARSP
50mm
Spliced Ridge Beam
Model: 45232WK
ZARSP
225mm
Step 2.
Use the ZARSP to connect at
the centre of the two ridge
beams. Be sure it is pushed in
fully.
Finished Spliced Ridge Beam
Finished
27/09/2018
1.30
11
Advertisement
