Table of Contents
Advertisement
Operation
Gobo Replacement
The gobos in gobo wheel 1 and 2 are removable from their gobo holders. This operation is quite simple,
although it requires the technician to carefully follow the recommended procedure.
•
Make sure to disconnect the product's power cord before replacing a gobo.
•
Always replace a gobo with a gobo of the same dimensions.
•
When inserting a glass gobo, always make sure that the shiny side of the gobo (glass base)
faces the lamp. This provides a layer of protection against the high temperature from the
lamp.
Procedure
1. Turn the product off and disconnect it from the power outlet.
2. Open the head cover by loosening the screws on the top cover.
3. Separate the gobo holder away from the gobo wheel by pushing it toward the front of the moving
head (direction 1 in the diagram). Be careful not to push the gobo out of the gobo holder.
4. Extract the gobo holder by pulling it outward (direction 2 in the diagram).
5. On a flat surface, remove the expansion ring that holds the gobo in place and remove the gobo
from the gobo holder.
6. Insert a new gobo and hold it in place with the expansion ring.
7. Slide the tip of the gobo holder under the pressure plate near the center of the gobo wheel.
8. Push the gobo holder inwards. DO NOT force the gobo holder into the gobo wheel slot. If correctly
installed, the gobo holder should easily slide into the gobo wheel slot.
Diagram
Locate
Maverick MK3 Profile User Manual Rev. 2
Pull Back
Remove
Gobo Holder
Gobo
Retaining Ring
Page 27 of 33
Advertisement
Table of Contents
