Table of Contents
Advertisement
4. Operation
Touchscreen Control Panel
The Maverick MK3 Profile has a touchscreen display as well as 6 control buttons. Navigate the menu
structure by pressing the buttons, touching the images of the buttons on the sides of the display, or
touching the desired menu option on the display directly. The touchscreen can be locked and calibrated
through the Setup options in the menu. (See
Control Panel Description
Button
Function
Navigates upwards through the menu list or increases the numeric value when in a function
Exits from the current menu or function
Navigates downwards through the menu list or decreases the numeric value when in a
function
Navigates leftwards through the menu list
Enables the currently displayed menu or sets the currently selected value into the selected
function
Navigates rightwards through the menu list
Battery Powered Display
The Maverick MK3 Profile has a battery powered display which enables access to the menu when the
product is powered off. Press and hold <MENU> until the display activates (approximately 15 seconds).
Home Screen
The Maverick MK3 Profile has a home screen that shows the current control protocols, personalities,
starting addresses, IP addresses, and universes. To see the home screen, press <MENU> repeatedly until
it shows on the display. From the home screen, touch any of the displayed control settings to immediately
jump to that part of the menu, such as the personality, starting address, or universe, or press <ENTER> to
reach the main menu.
Control Panel Lock
The setting locks or unlocks the control panel.
1. Go to the Settings main level.
2. Select the Lock Screen option.
3. Select NO (control panel stays unlocked) or YES (locks control panel).
When the control panel lock is activated, the product will prompt for the passcode in order
to access the menu. Enter the passcode as described below.
Passcode
After being prompted to enter the passcode, press <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.
Followspot Mode
The followspot mode disables the pan and tilt motors, allowing the output of the product to be aimed by
hand. To enable the followspot mode of the Maverick MK3 Profile, hold <UP> and <LEFT> while the
product is powering on. When the product is turned off and back on, the pan and tilt will return to normal
function.
Page 8 of 33
Touchscreen Calibration
and
Maverick MK3 Profile User Manual Rev. 2
Operation
Touchscreen
Lock.)
Advertisement
Table of Contents
