Clone Operation - Yaesu FT3DR Advanced Manual

Clone Operation

Data and various settings saved in your transceiver can be copied to any other FT3DR/
DE transceiver.
1. Turn OFF the power of both FT3DR/DE transceivers, then connect an optional clone
cable (CT-168) to the DATA terminal of each transceiver.
2. While pressing and holding the [DISP] keys on both FT3DR/DE transceivers, press
the POWER switch.
The two transceivers are turned on and placed in the clone mode. The "CLONE" ap-
pears on the display.
3. Touch [RECEIVE] on the receiving side transceiver.
The "WAIT" appears on the display.
4. Touch [SEND] on the transmitting side transceiver.
• The "TX" appears on the display and data transfer starts.
• When data transfer starts, the display on the receiving transceiver changes from
"WAIT" to "RX".
• When data transfer begins, the data transfer amount indicator appears on the
LCD.
5. When copying is completed, the receiving side transceiver returns to the normal
mode. On the transmission side transceiver, the indication on the LCD returns from
"TX" to "CLONE".
6. Turn OFF the power of both transceivers, then disconnect the clone cable.
• When the "ERROR" appears on the LCD during data transfer, copying cannot be
completed. Check the clone cable connection, and redo the operation from the
beginning.
• Time data cannot be copied.
DATA terminal DATA terminal
42