Using The Ac Power Adaptor; Setting The Clock; Menu Setting - Sangean PR-D17 Manual

Using the AC power adaptor

The AC power adaptor included with this unit is 9 volts DC at 0.7A center pin positive.
Insert the adaptor plug into the DC socket on the left side of the radio. Plug the adaptor into a standard AC outlet.
Whenever the adaptor is used, the batteries are automatically disconnected. The AC adaptor should be disconnected
from the main supply when not in use for long periods of time.
IMPORTANT
The AC adaptor is used as the means of connecting the radio to the power supply. The AC Adapter used for the
radio must remain accessible during normal use in order to disconnect the radio from the power supply completely.

Setting the clock

Upon initial use of the radio after the batteries have been installed or the AC adaptor is plugged in, the voice language
option "English" will flash on the display. Rotate the Tuning knob to select the required voice language and press the
Tuning knob to confirm the setting. The display will show -- --:-- -- . The clock can be set with the radios power on or off.
1.
Press and hold the Time setting knob for more than 2 seconds, the display will flash the time setting symbol
and also the hour digits.
2.
Rotate the Time setting knob to set the required hours.
3.
Press the Time setting knob, the minute digits will flash.
4.
Rotate the Time setting knob to set the required minute.
5.
Press the Time setting knob to complete time setting.
GB

Menu setting

E (Voice language
1.
Press the Menu button, the voice language option "English" (e.g.) will flash on the display. Rotate the Tuning knob
to select the required voice language. Press the Tuning knob to confirm the setting and enter the volume of the
voice setting.
2.
Rotate the Tuning knob to set the volume of the voice. Press the Tuning knob to confirm the setting and enter the
time format setting.
3.
The display will flash "12 HOUR" (e.g.). Rotate the Tuning control knob to select "12 HOUR" or "24 HOUR".
4.
Press the Tuning knob to confirm the time format setting and enter the AM tuning step setting.
5.
Rotate the Tuning control knob to select "10KHZ" or "9KHZ". (10K for America and 9K for most other countries)
6.
Press the Tuning knob to confirm the AM tuning step setting, then the software version will show on the display.
Rotate the Tuning knob to view software version or voice version.
7.
Pressing the Tuning knob will exit the software version or voice version display.
Tuning the radio- FM / AM
1.
Press the Power button to turn on the radio.
2.
Select the required frequency band by pressing the Band button. For the FM band fully extend and rotate telescopic
antenna to get best reception. For the AM band, rotate the radio to get the best signal. (Please note this radio has a
built-in AM antenna.)
3.
Rotate the Tuning knob to the desired frequency, shown in the display.
4.
Or press the Seek button to seek for the next available station.
To seek up in frequency, rotate the Tuning knob in a clockwise direction, then press the Seek button. Your radio
will seek in an upwards direction (low frequency to high frequency) and stop automatically when it finds a station of
sufficient strength.
05
Voice volume Time format AM tuning step Software / Voice version)