Factory Reset; Specifications - Sangean PR-D17 Manual

Factory reset

If your radio fails to operate correctly, or some digits on the display are missing / incomplete or you simply just want to
restore the radio to its original factory setting, carry out the following procedure.
By performing a factory reset, all user entered settings will be erased.
Press and hold the Power button and Preset 5 button at the same time, the "DEFAULT" will appear and flash on the
display. Continue holding down these two buttons until all the icons appear on the screen. Now the factory reset is
completed.

Specifications

Power Requirements
AC Power adaptor
Batteries
Battery Life
Frequency Coverage
Circuit Feature
Loudspeaker
Output Power
Headphone socket
Antenna System
Operating temperature range
The barcode label on the product is defined as below:
※
Sangean reserves the right to amend the specifications without notice.
If at any time in the future you should need to dispose of this product please note that: Waste electrical products
should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local
Authority or retailer for recycling advice. (Waste Electrical and Electronic Equipment Directive).
DC 9V 0.7A center pin positive
6 X UM-2 (C size)
Approx. 70 hours of listening for 4 hours a day at normal volume using alkaline
batteries
FM 87.5 -108 MHz
AM 522-1710 kHz (9 kHz / step)
AM 520-1710 kHz (10 kHz / step)
2.5 inches 8 ohm
800+800 mW
3.5mm diameter
FM telescopic antenna
AM built-in ferrite antenna
0°C to +35°C
Serial number
Production month
Production year
Product code
GB
E
08