Antenna Connections; External Amplifier Connections - Outlaw 975 Owner's Manual

Antenna Connections

Model 975 FM and AM
Antenna Connections
Supplied FM Antenna
Supplied AM Loop Antenna
FM Antenna
Connect the supplied FM antenna to the terminal labeled FM
75Ω. The Model 975's coaxial antenna terminal is designed
for push-on type antenna cable connectors. For a threaded
connector, use the supplied adapter.
The supplied FM antenna is for indoor use only. For best
signal reception you must fully extend the antenna. Experi-
ment with the antenna's position to obtain the strongest
signal. You can attach it to a wall or other surface using
push pins or similar hardware.
If FM reception is poor with the supplied indoor antenna,
the use of an amplified indoor or outdoor antenna is
recommended.
You can only connect a 75Ω type FM antenna to the Model
975. If you choose to use an antenna other than the one
supplied, be sure to verify that it has the correct type of connector
or that you obtain an appropriate adaptor.
If you use the same antenna for FM and TV signals, be sure
to install a splitter to separate the two signals.
24
AM Antenna
Connect the AM antenna to the terminals labeled AM 300Ω
on the rear panel of the Model 975. Press the spring-loaded
levers to open the terminals, insert a wire into each termi-
nal, then release the levers. Give the antenna cables a very
light pull to make sure they're connected.
If you experience reception problems, try turning the loop
antenna in a different direction.

External Amplifier Connections

Model 975 Power
Amplifier Connections
IMPORTANT NOTE: Before attempting to plug any
jacks into any power amplifier verify that the power
amplifier is turned off and/or disconnected from the AC power .
Failure to do so can potentially result in severe damage to your
amplifier and loudspeakers.
Power Amplifier
Use the audio jacks labeled 7.1 OUTPUT to connect the
Model 975 to an external power amplifier such as the
Outlaw Audio Model 7125 Power Amplifier. The Model
975 can output up to 7.1 channels of sound (seven main
speakers and one subwoofer channel) depending on source
components and material.
The output jacks on the Model 975 include (left to right):
back surround/front height L and R, side surround L and R,
front L and R, center and subwoofer.
If you are using a single surround back speaker as part of
a 6.1 channel system, make sure to use the surround back/
front height L output jack when connecting the Model 975 to your
external amplifier.
Outlaw Audio