Verify AC Circuit Capacity its rated power output, at the impedance rating of your speakers. Outlaw Audio is not The high power output of your Outlaw amplifier may require heavy power draw under responsible for damage to any speaker system or other component that is caused by using products whose power rating is lower than that of the amplifier.
Use the power cord to connect your amplifier to an AC power source. is on, the Standby/On indicator on the front panel illuminates. When it is (see page 7) off, all power is cut and the front STANDBY/ON switch will not function. Outlaw Audio...
This To assure that the high quality signals produced by your Outlaw amplifier are will insure that the maximum surface area of the plug is in contact with the carried to your speakers without loss of clarity or resolution, we recommend jack.
Amplifier Operation Power Control Connections The Outlaw 7075 features a built-in remote turn-on system that will automati- After all connections have been made you are ready for listening. First, turn on cally switch the amplifier when another device in the system is switched on.
Audible hum, or a discernable low frequency noise, is one of the most com- The Outlaw 7075 does not contain any user serviceable parts. If you suspect a mon problems in audio/video systems. This hum, which may be present even...
If the hum persists after all of the above suggestions have been tried, contact type grounding configuration. We recognize, however, that this may be imprac- the Outlaw Audio customer service department for assistance. Ground Loop Diagram Set-top Box...
1.00 Volts for Full Rated Output Remote Trigger Voltage 3 - 32 Volts DC at 5 milliamperes or greater Dimensions (HxWxD) 4.0” x 17.2” x 15.5” Weight 41 lbs Power Requirements 115VAC, +/- 3%, 50Hz - 60Hz 1200 watts, maximum Outlaw Audio...
Owner’s Manual In the event that you wish to return your Outlaw amplifier back to us, for any reason, please call to arrange for a Return Authorization Number. Damage from the performance of repairs by someone not authorized...