Assembly - Monitor - Proteus LDT-8850 Manual

e. Monitor
Put top handlebar ( 42 ) into upright tube unit ( 32,33 ), with screw ( 43 ) and washer ( 10 ) pre-fix
onto upright tube unit ( 33 ) but not fully fastened then put the other side with screw ( 43 ) and
washer ( 10 ) pre-fixed onto upright tube unit ( 32 ). ( whatever one end of screw could not be
touched, push the upright tube unit ( 32,33 ) inward to make screw touch the nut ). Put the screws on,
after fixing both end screws, not fully fasten while fixing.
Connect the upright tube ( right ) control wires (A) ( inside the upright tube assembly ( 5-pin ) onto
console control wire (D) ( on console assembly ( 5-pin ), Connect the upright tube elevation wire (B)
( inside upright tube ( 3-pin ) onto console elevation wire (E) ( on console ( 3-pin ).
13
Connect hand pulse sensor wire (C) ( inside
the upright tubes 32,33 ( 2-pin ) onto
console wire (F) ( on console 2-pin ), With
screw ( 58 ) pre-fixed console assembly ( 57 )
onto top handle bar of upright tubes ( 33,32 )
( this is top and bottom fix ). Then insert
console elbow ( 59 ) into console assembly
( 57 ), with screw ( 58 ) pre-fix, not fully
tighten. Do the final adjustment and fully
tighten the top handle bar screws.
D
59
F
58 38
42
57
F
58
43
A
B
40
C
E
39
41
33
B
A
B
A