Assembly - Base - Proteus LDT-8850 Manual

5 Assembly
a Note:
DO NOT FULLY TIGHTEN ALL FASTENERS UNTIL ASSEMBLY IS DONE.
DO NOT PLUG IN POWER SUPPLY UNTIL ASSEMBLY IS COMPLETED.
DO MAKE SURE ALL FASTENERS WELL TIGHTENED BEFORE USE.
b Machine base
Locate the main frame ( 1 ) on level floor, then adjust foot unit ( 4 ) to attach the floor. This
could steady the machine without causing wobble.
10
Method of adjusting foot unit
1. Use wrench to loose upper nut, then adjust lower screw.
2. Turn right, then foot unit on the rise.
3. Turn left, then foot unit goes down.
4
4. Adjust till the foot touch the floor.
5. Use wrench to adjust the upper nut clockwise,
CW
to fix onto main frame.
1
CCW