Table of Contents
Advertisement
Installing the Print Belt
5-10
1
Open the printer cover as shown
in
Figure 5-2.
2
Pull the print belt release lever forward to loosen belt tension as shown in
Figure 5-10.
3
Lift the print belt off the pulleys, and store the belt in a safe location.
4
Follow the "Installing the Print Belt" procedure that follows when replacing the
print belt.
Figure 5-12. Installing the Print Belt
Dse this procedure to install the print belt:
1
If a print belt is on the printer, follow the "Removing the Print Belt" procedure
above to remove the belt.
2
Raise both ribbon guides as shown· in Figure 5- 7.
3
Hold the print belt with the type up, and carefully place the belt around the
pulleys and in back of the belt guard as shown in Figure 5-12.
Note: Do not place the belt all the way to .the bottom of the pulley.
4
Move the print belt release lever to the rear to tighten the belt on the pulleys as
shown in Figure 5-1
OA
5
Tum the print belt pulley counterclockwise, and observe the print belt as it moves
on the pulleys as shown in Figure 5-12.
Note: If the belt does not move down on the pulleys, there is interference below the belt or
the belt is positioned incorrectly; to correct tl:iis, remove the belt, check the belt path for
interference, and install the belt again.
','
}
\.~
...
·
' '
j
"'-"'
Advertisement
Table of Contents
