Resetting Lock To Factory Default; Factory Settings - Assa Abloy Emtek EMPowered Manual

Resetting Lock to Factory Default

When lock is reset to factory defaults, all User Codes (including the Master PIN Code*)
are deleted and all programming features are reset to original default settings (see
below).
1. Remove battery cover and batteries.
2. Remove the interior escutcheon to access the reset button.
3. The reset button (see page 8, Step 5) is located beside the PCB cable connector.
4. While pressing the reset button (Minimum of 3 seconds) reinstall batteries.
Release reset button.
5. Replace battery cover.
Upon reset, Master PIN Code creation is the only option available and must be
performed prior to any other programming of the lock.

Factory Settings

Master PIN Code
Automatic Re-lock
Inside Indicator Light
One Touch Locking
Volume Setting
Language Setting
Lockout Mode
Automatic Re-lock Time
Wrong Code Entry Limit
Shutdown Time
*The Master PIN Code must be registered prior to any other programming of the lock.
16
Settings Factory Settings
Registration required*
Disabled
Disabled (Off)
Enabled
Enable (Low)
English
Disabled
30 Seconds
5 Times
60 Seconds