Definitions - Assa Abloy Emtek EMPowered Manual

Definitions

All Code Lockout Mode: This feature is enabled by the Master PIN Code. When enabled, it restricts all
user (except Master) PIN Code access. When attempting to enter a code while the unit is in Lockout, the
RED locked padlock will appear on the screen.
Automatic Re-lock Time: After a successful code entry and the unit unlocks, it will automatically re-lock
after thirty (30) seconds.
Inside Indicator Light: Located on the interior escutcheon. Shows active status (Locked) of lock and can
be enabled or disabled in the Advanced Lock Settings (Main Menu selection #3).
Language Setting Mode: Choosing English (1), Spanish (2) or French (3) becomes the (default) setting for
the lock's voice prompts.
Low Battery: When battery power is low, the Low Battery Warning indicator flashes RED. If battery power
is completely lost, use the 9 Volt battery override. To use the 9V battery override apply 9V battery, in either
direction, to terminals below the touchscreen for backup power option. Wake up the lock and enter your
PIN Code to unlock the door.
Master PIN Code: The Master PIN Code is used for programing and for feature settings. It must be
created prior to programming the lock. The Master PIN Code will also operate (unlock/lock) the lock.
Network Module Settings: With the optional Network Module installed, this setting becomes available thru
the Main menu (7) and allows the lock to connect with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch (during
Automatic Re-lock duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is not in
use (disabled), any valid PIN Code will re-lock the lock.
Previous: While in Menu Mode, pressing this icon cancels the current operation and returns the user to the
previous step.
Privacy Mode: Privacy mode is disabled by default Privacy mode is enabled/disabled in the app.
Shutdown Time: The unit is shutdown (flashing RED) for sixty (60) seconds and does not allow operation
after the wrong code entry limit (5 attempts) has been met.
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
User PIN Code: The User Code operates the lock. Maximum number of User Codes is 250 with Network
Module; without Network Module maximum is 25 User Codes. Note: When deleting User Code(s), screen
will display User Number (not code) being deleted.
Volume Setting Mode: The volume setting for PIN Code verification is set to Low (2) by default; otherwise
it can be set to High (1) or Silent (3) for quiet areas.
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid PIN Code, the unit will
shut down and not allow operation.
17