Playing A Tape - Sony MHC-ZX10 Operating Instructions Manual

Tips
• If you want to record from the reverse side, press
TAPE B n to light its indicator after pressing
REC PAUSE/START in step 4.
• When you record on both sides, be sure to start
from the front side. If you start from the reverse
side, recording stops at the end of the reverse side.
• To record non-preset stations, use m and M in
step 2 to tune in the desired station manually.
• When you want to reduce the hiss noise in low-
level high-frequency signals, do the following
procedure after pressing REC PAUSE/START in
step 4.
1 Press MODE SELECT repeatedly to select "Set
Up Mode", then press PUSH ENTER.
2 Move the multi stick toward b or B repeatedly
to select "TAPE Set Up ?", then press PUSH
ENTER.
3 Move the multi stick toward b or B repeatedly
to select "DOLBY NR Set Up ?", then press
PUSH ENTER.
4 Move the multi stick toward b or B repeatedly
to select "On", then press PUSH ENTER.
"DOLBY NR" appears in the display.
To return to the original setting, repeat steps 1
tthrough 4 and select "Off" in step 4.
• If noise is heard while recording from the radio,
move the respective antenna to reduce the noise.

Playing a tape

You can use any type of tape, TYPE I (normal),
TYPE II (CrO ) or TYPE IV (metal) , since the
2
deck automatically detects the tape type. You can
also use . and > to quickly search for songs
you want to hear.
?/1
2 7
(Power)
. >
V
B b
v
Multi stick
3
x
PUSH ENTER
VOLUME
1 m M
x
. >
m M
TAPE A N
TAPE B N
MODE SELECT
ENTER
VOL +/–
B/b
continued
17