Other Commands - Xeos Technologies Inc. Rover User Manual

Other Commands

Below is a list of other commands that can be sent via Iridium or Bluetooth to acquire additional
information, or configure the Rover. Remember to add the $ symbol ahead of any commands.
Iridium or Bluetooth
Command Parameters
ver ---
Status ---
startmsg ---
sysInf ---
scm ---
FactoryDefaults ---
btPwr 1/0
batt ---
settings ---
stats ---
statsL ---
switch X 1/0
MsgEnable timer#
m1,m2,etc
ReportHour Hour (0 – 23)
RepMinute X (Minutes)
WCEnable 1/0
WCInner X
ResetNow ---
Bluetooth
btpcycle ---
btName Insert Name
fdumpall ---
Rover User Manual Version 3.0
Description
Show hardware and firmware versions (V-Type message)
Show uptime/current timer mode/volts/orientation
Combination Ver/Timer/Short Settings message
GPS/Ird summary (I-Type message)
Status Change Message (S-Type message)
Set all configuration to defaults and reset device
Bluetooth power On/Off
Show battery status
Show all settings
Show statistics (since last powerup/reset)
Show Lifetime Statistics
Switch component X On/Off. No parameter lists components
Set & Show which messages are enabled for each Timer
Set/Show Daily Reporting Hour offset from UTC
Minutes offset past the hour for GPS/Iridium
Watch Circle Enable/Disable
Watch Circle percent of radius for elevated GPS monitoring
Restarts the system. The effect is the same as restarting via the
magnet
Power cycle Bluetooth
Set Bluetooth name for the Rover, changes after $btpcycle
Print out Flash Memory of the Rover (Bluetooth Only)
31