Table of Contents
Advertisement
Testing the Rover
Before testing
The following should be confirmed ahead of testing:
1) The Rover should be confirmed activated on the Iridium network to ensure that any
messages transmitted are able to be received, and directed to send messages to the
intended destinations.
2) Each battery used during the test should be examined with a voltmeter to ensure none of
the cells are defective or discharged. Individual cells with a voltage measuring less than
1.5 V should not be used, but new batteries should be used during deployments.
3) Xeos recommends the Energizer EN91 AA alkaline battery, or the Energizer L91 lithium
Battery. Duracell batteries should not be used as they are prone to leaking under some
conditions.
Testing
Power-up and Batteries
1) Insert the batteries into the device in the
proper orientation. Labels on the battery core
indicate the direction to add the cells.
2) As the last batteries are added, the Rover will
turn on automatically.
If there are still cells missing during
the battery self-test, the Rover will
beep and flash its red LED. This should cease when all batteries are added, so long
as they are of good health.
If the red LED continuously flashes, and/or beeping is heard when all batteries are
added, a self-test failure has occurred. Recheck the batteries and their orientation
first, and if this persists, contact Xeos.
3) Once all LED action has ceased, use a magnet to find the magnetic on/off switch on the
device (the green LED will illuminate on detection). Use this opportunity to turn the device
off by swiping the magnet repeatedly at this location (OFF is indicated by a solid RED LED)
to confirm proper operation of the magnetic switch. Use the same method to turn the
device on (ON is indicated by a solid GREEN LED).
Transmission
1) Place the device upright in a location outside that has as much of the sky visible as
possible; buildings and other tall objects can impede a beacon's ability to transmit.
2) The following messages are to be expected from the Rover after turning on within five
minutes:
a. A power-up message displaying the firmware version and serial number:
Rover User Manual Version 3.0
32
Advertisement
Table of Contents
