Other Commands - Xeos Technologies Inc. Resilient User Manual

Other Commands

Below is a list of other commands that can be sent via Iridium or Bluetooth to acquire additional
information, or configure the Resilient. Remember to add the $ symbol ahead of any commands.
Command Parameters
ver ---
Status ---
sysInf ---
FactoryDefaults ---
btPwr 0/1
btTOut Insert Name
btName X
btpcycle ---
batt ---
settings ---
stats ---
statsL ---
switch X 0/1
MsgEnable timer# m1,m2,etc
ReportHour Hour (0 – 23)
RepMinute Minute
WCEnable 1/0
WCInner [x]
ResetNow ---
Resilient User Manual Version 2.0
Description
Show hardware and firmware versions.
Show operating status
GPS/Ird summary
Reset all to defaults and reset.
Bluetooth power On/Off
Bluetooth timeout (Minutes)
Set Bluetooth name for the Resilient
Power cycle Bluetooth
Show battery status
Show all settings.
Show statistics (since last powerup/reset)
Show Lifetime Statistics
Switch component X on/off. No parameter lists components
Set & Show which messages are enabled for each Timer.
Set/Show Daily Reporting Hour offset from UTC
Minutes offset past the hour for GPS/Iridium
Watch Circle Enable/Disable
Watch Circle percent of radius for elevated GPS monitoring
Restarts the system. The effect is the same as restarting via
the magnet
23