Status Change Message (Type S) - Xeos Technologies Inc. Rover User Manual

Status Change Message (Type S)

Status messages are sent from the device when there has been a change to the operation of the
device, whether a timing change between modes (start-up mode to normal mode, alarm mode
to normal mode) or changes to the watch circle details. If watch circle is not enabled, its
information is omitted. This message is always sent in ASCII format.
Status Readout – Watch Circle Disabled
03151218
S
Status / Value Change
gps = 10Mns
ird = 10Mns
lat=47.57143
lon=-53.56037
Sched hr = 0
Status Readout – Watch Circle Enabled
03151218
S
Status / Value Change
gps = 10Mns
ird = 10Mns
ctr
lat=47.57143
lon=-53.56037
rad=765m
Sched hr = 0
Rover User Manual Version 3.0
S-Type Message with Watch Circle Disabled
Timestamp in UTC (Month/Day/Hour)
Type of message (Status Change)
Indicates that a setting has been changed
Currently used GPS repetition rate
Currently used Iridium repetition rate
Latitude of latest fix
Longitude of latest fix
Timing offset of Iridium/GPS sessions from UTC, set via $reporthour
S-Type Message with Watch Circle Enabled
Timestamp in UTC (Month/Day/Hour)
Type of message (Status Change)
Indicates that a setting has been changed
Currently used GPS repetition rate
Currently used Iridium repetition rate
Indicating the lat/long/radius below are the centre of the circle
Latitude of installed watch circle
Longitude of installed watch circle
Radius of the watch circle in meters
Timing offset of Iridium/GPS sessions from UTC, set via $reporthour
15