Table of Contents
Advertisement
INSTALLATION
C.
Install Awning
1. LIFTING HAZARD. Use proper
lifting technique and control when lifting product.
Failure to obey this caution could result in injury.
With a mechanical lift, or the help of additional
personnel, lift awning up to mounting bracket.
D o NOT hook onto mounting bracket until
wiring is routed.
2. With the help of additional personnel, hook aw-
ning onto mounting bracket. See (FIG. 9).
FIG. 9
Awning
Mounting Bracket
RV Wall (Structure Not Shown)
3. IMPACT OR CRUSH HAZARD. Do
NOT extend awning until it is securely [mounted
/ hooked] onto mounting bracket(s). Take special
care when extending. Otherwise, awning could
dislodge and fall. Failure to obey this warning
could result in death or serious injury.
Carefully extend awning approximately 1'. Then
verify awning's back rail is fully contacting mount-
ing bracket's vertical surface. See (FIG. 10).
FIG. 10
Back Rail
Sleeves (Optional
-Installer Cut To Length)
Backing Plate
(Optional-Installer Supplied)
No Gap
Mounting
Bracket
4. IMPACT OR CRUSH HAZARD.
Do NOT operate or leave awning unattended un-
til it is securely fastened to mounting bracket(s).
Otherwise, awning could dislodge and fall. Fail-
ure to obey this warning could result in death or
serious injury.
Place and tighten self drilling screws through
mounting bracket and into awning's back rail.
See (FIG. 11).
FIG. 11
Awning
Back Rail
Self
Drilling
Screw
7
Backing
Plate
(Optional-
Installer
Supplied)
Sleeves
(Optional
-Installer Cut
To Length)
Mounting
Bracket
Advertisement
Table of Contents
