Sony HCD-C5 Service Manual page 18

HCD-C5
3-12. SPINDLE MOTOR ASSY (M904)
1 clip arm spring (L)
3-13. JACK BOARD, HP BOARD, REAR COVER
Note for re-installation-1
When installing the rear cover,
be careful that the three harnesses
coming from
" 2 Connector (CN107)",
" 5 Connector (CN109)",
" 6 Connector (CN110)",
and the harness coming from the
DC fan (M901) must not contact the
heat sink (IC902) and the diode
(D981) and the heat sink (IC904).
18
3 open to direction of the arrow A
A
8 spindle motor assy
(M904)
1 screw
(+BVTT 3 x 5)
5 connector
(CN109)
2 four screws
(+BV 3 x 12)
9 two nuts
3 three screws
(+BV 3 x 8)
POWER board
heat sink (IC902)
diode (D981)
2 clip arm spring
7 spindle motor
4 screw
(+PTPWH 3 x 8)
6 connector
(CN110)
(N4)
2 connector
Note for re-installation-2
When installing the rear cover, be careful that the three
harnesses coming from
" 2 Connector (CN107)",
" 5 Connector (CN109)",
" 6 Connector (CN110)",
and the harness coming from the D.C. fan (M901) must not
be pinched by the rear cover, the UCOM board, power
transformer (T900) and tuner pack.
4 two screws
(+P 1.7 x 2.2)
5 turn table
6 washer
8 two screws
7 HP board
q; rear cover
3 JACK board
1 two screws
(CN107)
(+BV 3 x 8)
(+B 4 x 16)
D.C.fan
(M901)