Turn Signals; Windshield Wipers; Daytime Running Lights - Subaru Outback 2020 Getting Started Manual

CONTROLS

Daytime Running Lights

The daytime running lights automatically turn on when the engine has started, the parking
brake is fully released, the light switch is in the Off, "AUTO" (if equipped) or " "
position, and the select lever is not in the "P" position. Always turn on the headlights when
it's dark outside by rotating the dial to the " " or "AUTO" position.

TURN SIGNALS

Push slightly up for right lane change or fully
up for right turn signal. Push slightly down for
left lane change or fully down for left turn
signal.

WINDSHIELD WIPERS

To turn on the wipers, press the wiper control
lever down one position for intermittent, two
positions for low speed, or three positions for
high speed. To turn the wipers off, return the
lever to the "OFF" position. For a single wipe,
move the lever up one position.
When the lever is in the intermittent position,
rotate the dial to adjust the operating interval
of the wipers.
Pull the lever toward you to spray washer fluid.
The washer will spray until you release the lever, then wipe twice.
26