Table of Contents
Advertisement
3
Installation Guide
3.1 Hardware Installation
3.1.1 RTV Series
Use the following steps to install the RTV series board on the PCI
bus:
1. Remove the computer cover using the instructions from
the computer manual.
2. Check that there is an empty PCI (32-bit) slot t accom-
modate the board. If there is not an empty slot, remove a
PCI board from the computer to make room for the RTV-
24 board and take note of the chosen slot number.
3. Remove the blank metal plate located at the back of the
selected slot (if any). Keep the removed screw to fasten
the RTV-24 board after installation.
4. Carefully position the RTV-24 in the selected PCI slot as
illustrated below. If using a tower computer, orient the
board to suit the board slots.
5. Once perfectly aligned with an empty slot, press the
board firmly but carefully into the connector.
Installation Guide
Figure 3-1: RTV-24 Installation
43
Advertisement
Table of Contents
