Sony BDV-IT1000 Operating Instructions Manual page 72

19
Press X/x to select [OK].
To cancel, select [Cancel].
Note
• Make sure that the headphones are not
connected to the surround amplifier. You cannot
operate the following steps with the headphones
connected.
20
Press .
[Auto Calibration] starts.
The system adjusts the speaker setting
automatically.
Be quiet during the measurement.
Note
• Loud test sound is output when [Auto
Calibration] starts. You cannot turn the volume
down. Give consideration to children and
neighbors.
• Before [Auto Calibration], install the surround
amplifier in the appropriate location. If you
install the surround amplifier in an improper
location, such as another room, proper
measurement will not be obtained.
• Avoid being in the measurement area and
making noise during the measurement (which
takes about 1 minute), as it may interfere with
measurement.
• When you use the surround back speakers with
the optional surround amplifier, install the
speakers in appropriate location and turn the
surround amplifier on.
21
Confirm the conclusions of [Auto
Calibration].
The conclusions appear on the TV screen.
Press C/c to change the page. The first page
shows the distance of speakers. The second
page shows the level of speakers. If the
conclusions are ok, unplug the calibration
mic and press X/x to select [OK].
Note
• The environment of the room in which the
system is installed may affect measurements.
• If measurement fails, follow the message then
retry [Auto Calibration].
22
Press .
Easy Setup is finished. All connections and
setup operations are complete.
72
GB
To quit the Easy Setup
Press HOME in any Step.
Tip
• If you change the position of the speakers, reset the
speaker settings. See "Calibrating the Appropriate
Settings Automatically" (page 108) and "Setting the
Speakers" (page 110).
• If you want to change any of the settings, see
"Settings and Adjustments" (page 117).
To recall the Easy Setup Display
1
Press HOME.
The home menu appears on the TV screen.
2
Press C/c to select
3
Press X/x to select [Easy Setup], then
press .
4
Press C/c to select [Start], then press
.
The Easy Setup display appears.
[Setup].