8.
Press NEXT to program Slave System.
Display example: SLAVE : C; E1; E2
9.
Repeat steps 3 through 7.
10.
Press END.
Conditions
• In case of starting the system for the first time or System Data Clear, the application for
location will adapt the practical installation instead of system default setting.
• There are two expansion areas on the KX-TD816, areas 1 and 2 from bottom to top. There
are three expansion area on the KX-TD1232, areas 1, 2 and 3 from bottom to top.
• If the Slave System is out-of-service or in case of KX-TD816, skip the steps 8 and 9.
• After changing the setting, to make your setting effective, unplug the system once and plug
it in again. Otherwise the previous setting will be maintained.
Feature References
Module Expansion
DECT Programming
1.1 DECT Programming
9