Start-Up; Operation - JAUDT FSV 6110 Series Translation Of The Original Operating Instructions

Operating Instructions FSV 6110...
4.1.3 Notes on installation
Clean flange surfaces.
Align the JAUDT vario-slide valves such that the opening forms a funnel for the flow-
ing bulk material.
Fit a seal at the pipe flanges (not supplied).
Caution Material Damage!
Install the JAUDT vario-slide valve free of tension - otherwise risk of material damage.
Carefully observe the following installation instructions.
Align the JAUDT vario-slide valve with respect to the piping system.
Check parallel alignment of the counterflanges.
Tighten the connection elements crosswise.
Max. tightening torques:
M8 M10
10 Nm 20 Nm
4.2

Start-up

Start-up work should only be carried out by specially trained personnel.
Work on the electrical system must only be carried out by a qualified electrician.
Caution Danger of Injury!
Make sure that the system is switched off and secured
to prevent it being switched on again. Inform the control room.
Check the JAUDT vario-slide valve when installed
for low-noise and smooth operation of the slide valve
for leaks
that the securing elements are firmly tightened
Additional checks for power-operated versions:
Check the electropneumatic system with regard to function and leaks.
Check that the electric motor is connected correctly.
Inductive limit switch: Check the switch positions "Slide valve OPEN" and "Slide valve CLOSED".
4.3

Operation

Observe the notes on safety.
Operation of JAUDT vario-slide valves is simple in all drive variants.
Caution Danger of Injury! – Manually operated vario-slide valves:
Always wear protective gloves when metering hot materials
– Danger of burns.
Depending on the type, open and close the JAUDT vario-slide valves with the handle, hand crank, hand
wheel, ratchet, sprocket, electric motor or electropneumatic drive.
© BA6110.0002_EN_Rev11.docx
M12 M16 M20
35 Nm 90 Nm 150 Nm
M24 M27
200 Nm 250 Nm
M30
300 Nm
Page 7 of 19